After replacing the logic board or ink cartridges you must re-calibrate the Color StyleWriter 4500 banner printing. Performing this calibration requires using the Color StyleWriter 4500 Banner Calibration utility found in this folder.
Note: Only the Color StyleWriter 4500 has banner printing.
Installation
Copy the Color SW4500 Banner Calibration utility to your hard drive.
Using the Tool
1) Connect the Color StyleWriter 4500 to the Macintosh and power on the printer. Make sure ink cartridges are installed and there is paper in the printer.
2) Set the banner lever to the cut-sheet (left-most) position. The banner lever must be in the cut-sheet position or the paper may be misaligned and banner paper may not be picked.
3) Launch (double-click) the Banner Calibration utility.
4) In the Banner Calibration dialog window, select the serial port that is being used by the printer, and click Send File.
5) Wait until the utility completes the calibration routine and prints a slightly modified Diagnostic Test page.
6) Observe the Pen State value on the Diagnostic Test page printout. The number should fall within the range of 140-230.
• If the number is less than 140, verify that the banner lever is positioned all the way to the left.
• If the number is greater than 230, verify that the pivot assembly is installed correctly in the printer.
7) Once you have verified that the values have been properly written to the printer, power it off.
